MBF profile wrapping machine installs the cut diaphragm on the hanging film shaft, adjusts the position, picks up the rubber box, passes the film through the upper film roller, passes through the gap in the bottom of the rubber box, and adds the glue to the glue box. Pull the slanting iron a little narrower than the width of the diaphragm. Adjust the screws on both sides of the front end of the plastic box to control the thickness of the glue. The thickness of the glue is determined according to the type of glue, and generally 50-100 grams per square meter of glue.
Temperature requirements for MBF profile wrapping machine
MBF profile wrapping machine is different according to ambient temperature and coating speed, the main heating setting is between 40-80C°, and the ambient temperature is not lower than 16C°. Auxiliary heaters and heat guns can be used for auxiliary heating before rolling to achieve the desired coating effect.
Maintenance and maintenance of MBF profile wrapping machine
1. The working environment should be kept clean to prevent the dust from falling into the rubber coating system and affect the quality of the coating.
2. After the first use of the lubricating oil in the reducer, the new lubricating oil should be replaced, and then replaced every six months. When the workload is large, replace it once every three months. When the temperature is high in summer, the viscosity of the reducer should be replaced. When the temperature is low in winter, the gear oil with low viscosity should be replaced. Transmission system: sprocket drive, the chain part is added with butter once a month. In the case of a gear transmission system, the turbine seat should be greased once every two weeks. If the turbine seat is oil-free, the butter should be added twice a week.
3. After the work is completed, the total power must be turned off.
4. When repairing or adjusting parts, they should be handled by relevant professionals. www.cnyudajixie.com