Position adjustment and substrate requirements for film wrapping machine for pvc ceiling panels

- May 08, 2019-

The film wrapping machine for pvc ceiling panels adopts various molding pressure rollers to simulate the manual veneer movement during use. When used, the surface decoration material is attached to the surface of the substrate. When used, the center line or the highest point of the profile is generally selected or The lowest point is used as the starting point, and the pressure wheel is fixed along the contour of the surface of the profile, point by point, and sequentially, to form an envelope of the contour of the profile.

Film wrapping machine for pvc ceiling panels cladding material

1, the substrate: wood lines, MDF, wood plastic, plastic steel, PVC, aluminum profiles and other lines. Substrate requirements: For regular line profiles, there may be grooves and curved surfaces, but each point must be straight in the longitudinal direction and have a certain pressure resistance. The length is generally 40 cm or more to infinity.

2, veneer materials: PVC decorative film, decorative paper, solid wood leather, Boeing board, composite aluminum film. The width is determined by the substrate requirements and the selected model, typically less than 50 cm.

The film wrapping machine for pvc ceiling panels mounts the cut diaphragm on the hanging film shaft, adjusts the position, picks up the rubber box, passes the film through the upper film roller, passes through the gap in the bottom of the rubber box, and adds the glue to the glue box. Pull the slanting iron a little narrower than the width of the diaphragm. Adjust the screws on both sides of the front end of the plastic box to control the thickness of the glue. The thickness of the glue is determined according to the type of glue, and generally 50-100 grams per square meter of glue.

www.cnyudajixie.com