Operation requirements and working process of hot stamping machine for Pvc panels

- Jun 22, 2019-

In the process of hot stamping machine for Pvc panels, it mainly adopts intelligent digital temperature time display, automatic constant temperature, automatic timing, heating plate and heating plate injection, safe, durable, uniform heat distribution, high temperature resistant silicone bottom plate to make baking pressure More uniform, no deformation at 300 °C, automatic time control, convenient pressure adjustment.

hot stamping machine for Pvc panels operation requirements

1. Pull the rocker up, make the heating plate fully open and plug in the power supply, turn on the main power switch, and the indicator light is on;

2. Adjust the left temperature regulator (the three buttons represent the single digit, ten digits, and hundred digits respectively), press + or - to adjust to the appropriate temperature (150 °C - 200 °C), and the heating time is about 15-20 minutes.

3. Adjust the right timer knob to adjust to the appropriate time (the length of time depends on different materials).

4. When the temperature reaches the set value, the machine will automatically enter the constant temperature state.

5. Place the plate flat on the printing table, then stack the picture (the size of the picture page must be larger than the size of the plate to prevent the edge from being indented and affect the effect of the product). Press the rocker hard down. Note: the pressure cannot be exceeded. Large, otherwise it will cause the rocker to deform!

6. When the time is up, the buzzer will sound. At this time, raise the rocker and take out the plate (make it immersed in cold water after removal to prevent the ink from spreading). Dry it. www.cnyudajixie.com