Installation adjustment and coating requirements for film wrapping machine for aluminum profiles

- Apr 26, 2019-

The film wrapping machine for aluminum profiles needs to determine 2-3 operators, and the equipment should be installed in a clean environment and level ground workshop. After the equipment is in place, remove the accessories on the machine and check and verify according to the packing list. Adjust the anchor bolts so that they are evenly stressed to bring the fuselage to a level.

The film wrapping machine for aluminum profiles is effective in inspecting the equipment for damage during transportation. This machine uses 380V three-phase four-wire power supply. The power line should be greater than 2.5mm2, and the rightmost line of the power supply line is zero line. The machine is installed with a grounding wire according to the grounding standard. Turn on the power to check if the motor, heater, lighting, etc. are normal.

The film wrapping machine for aluminum profiles adjusts the distance between the two rows of conveyor wheels according to the width, shape and cladding requirements of the profile; adjusts the width and height of the ruler and the platform to make it suitable for the coating requirements of the profile, and install the guide wheels on both sides. The profile is parallel to the direction of movement of the transport wheel.

Installation and adjustment of the pressure roller of film wrapping machine for aluminum profiles: adjust the small pressure roller according to the profile of the profile surface. Generally, select the center line or section of the profile, the highest point or the lowest point of the main curve of the profile, and make a point-by-point transition and rolling along the contour of the profile. . The profile is laminated to the membrane. Install a small pressure roller to balance the lines and move them at the same time. There is a pressure roller on the top, and the support wheel must be installed at the bottom to balance the lines up and down and left and right. Otherwise, the line joints will be unreal. In the large plane, the small pressure roller can be used to gradually roll from the center to the two sides. At the 90° corner, the small pressure roller needs to be used for 3 times. For complex shapes, small pressure rollers need to be arranged naturally and cannot be forced to form. In particular, the decoration of decorative paper should be natural and smooth.www.cnyudajixie.com