How to use desktop manual Foam Board Hot Stamping Machine

- Jan 01, 2021-

1. Adjust the upper hand wheel of the manual hot stamping machine to the required pressure. 2. Set the pointer of the manual hot stamping machine to the required temperature, the green light will go off after 2-3 minutes, and the red light will be on. Automatic temperature control will always control the temperature at the set temperature point. 3. Put a layer of universal glue on the electric board to be bronzed, and place the glue upwards in the table where you want to put the product, and press down the handle of the manual bronzing machine for a few minutes. 4. After installing the hot stamping paper and powering on, press the manual hot stamping machine to automatically pass the paper and it will take a stroke. The length of the automatic paper-passing stroke is controlled by a 0-10 second delay relay. 5. Put the product on the manual hot stamping machine and put it on the paper table for hot stamping.

https://www.cnyudajixie.com