Hot stamping machine for PVC panel operation requirements and precautions

- Apr 30, 2019-

The hot stamping machine for PVC panel effectively pulls the rocker up during the use, so that the heating plate is fully opened and plugged in, the main power switch is turned on, the indicator light is on, and the left temperature regulator is adjusted (the three buttons respectively represent Units, tens, and hundred), press + or - to the appropriate temperature (150 ° C -200 ° C), the heating time is about 15-20 minutes.

 

The Pvc plate hot stamping machine adjusts the right timer knob to adjust to the appropriate time (the length of time depends on different materials). When the temperature reaches the set value, the machine will automatically enter the constant temperature state. Place the plate flat on the printing table, then stack the picture (the size of the picture page must be larger than the size of the plate to prevent the edge from being indented, affecting the final effect of the product), and press the rocker hard; Note: the pressure should not be too large Otherwise it will cause the rocker to deform!

 

When the Pvc board hot stamping machine arrives, the buzzer will sound. At this time, raise the rocker and take out the plate (make it immersed in cold water after taking out to prevent the ink from spreading). Dry it, and the temperature of the baked metal plate is generally 170-180 ° C, time is 20-40 seconds, the temperature of the baked porcelain plate is generally 180-190 ° C, the time is 60-90 seconds.

 

https://www.cnyudajixie.com/