Edge banding printing machine operation and start-up requirements

- Jun 18, 2019-

Before the operation of the edge banding machine, the workers must dress the work clothes, work hats and work shoes neatly, fasten the placket and cuffs, and do not install the clothes in the pockets, and do not wear watches and accessories. Before starting the machine, add the required lubricant (grease) to each oil filling point, lubrication point and fuel tank of the machine.

The edge banding printing machine is not approved, and the crew members are not allowed to start and operate the machine without authorization. The assistants and apprentices should work under the guidance of the leader. Before starting the machine, check the parts of the fuselage for any debris. You must first give a signal (press the safety bell), echo the front and back, and make sure that the machine is safe before starting.

Before the machine is running, first reverse the number of weeks, and then a few weeks, in order to avoid debris between the rollers to damage the blankets, plates and so on. During the operation of the machine, it is strictly forbidden to touch the moving working surface by hand. It is not allowed to repair and wipe the machine. It is not allowed to cross the rotating part, and the machine protection device must be kept complete.

The crew of the edge banding printing machine should strictly observe the position according to the division of labor, pay attention to the operation of all parts of the machine at all times, and immediately stop the problem after finding the problem. The work site should be kept clean and tidy, the ground. There is no debris around the workbench and the machine, and the maintenance tools and spare parts should be placed in the specified position.www.cnyudajixie.com