First of all, the pneumatic hot stamping machine will inevitably be affected by the external environment during use. Once some dirt enters the inside of the equipment, it will inevitably cause the use of the printing machine to malfunction. Under more severe conditions, even mechanical use may occur. Conditions of reduced life span. So it is very important to have a clean environment and keep the appearance clean. In fact, it is not difficult to do this. Cleaning the environment before work every day and cleaning the machine after work can basically ensure the proper use of it. Another point is the lubrication of the pneumatic hot stamping machine, which can be carried out according to the operation of the equipment for a period of time. First cut off the power and steam source of the screen printing machine, etc. to ensure safety, and then wipe the old oil stains on the movable parts, guide rods and other places and apply clean lubricating grease. It is also necessary to check the tightness of the firmware of the pneumatic hot stamping machine. It is particularly important to note that the fastening screws of some aluminum parts must not exceed a certain torque, as long as the tightening is done, otherwise it will easily cause slippage.