Commissioning and installation process of MBF profile wrapping machine

- Jul 02, 2019-

In the process of installation, the MBF profile wrapping machine determines 2-3 operators of the machine, and the equipment should be installed in a workshop with clean environment and smooth ground. After the equipment is in place, remove the accessories on the machine and check and verify according to the packing list. Adjust the anchor bolts so that they are evenly stressed to bring the fuselage to a level.

The MBF profile coating machine has a certain degree of bump damage during transportation. This machine uses 380V three-phase four-wire power supply. The power cord should be greater than 2.5mm2, and the right side of the power supply line is a zero line. The machine is installed with a grounding wire according to the grounding standard. Turn on the power to check if the motor, heater, lighting, etc. are normal.

Commissioning of MBF profile wrapping machine

1. Profile positioning: Take a well-made profile. Requirements: Can not bend or twist, put it on the bed conveyor wheel, adjust the distance between the two rows of conveyor wheels according to the width, shape and coating requirements of the profile. Adjust the width and height of the ruler and the platform to suit the coating requirements of the profile; install the guide wheels on both sides to make the profile parallel to the direction of movement of the conveyor.

2. Installation and adjustment of the pressure roller: Install and adjust the small pressure roller according to the surface contour of the profile. Generally, select the center line or profile of the profile, the high or low point of the main curve of the profile, and make a point-by-point transition and crushing along the contour of the profile. The profile is laminated to the membrane. Install a small pressure roller to balance the lines and move them at the same time. There is a pressure roller on the top, and the support wheel must be installed at the bottom to balance the lines up, down, left and right. Otherwise, the line joints will be unreal. In the large plane, the small pressure roller can be used to gradually roll from the center to the two sides. At the 90° corner, the small pressure roller needs to be used for 3 times. For complex shapes, small pressure rollers need to be arranged naturally and cannot be forced to form. In particular, the decoration of decorative paper should be natural and smooth.www.cnyudajixie.com